Описание оборудования | |
---|---|
Control interface unit IDENTControlCompact with EtherCAT interface | |
General specifications | |
Number of read/write heads | max. 2 alternatively 1 read/write head and 1 trigger sensor |
UL File Number | E87056 |
Indicators/operating means | |
LEDs 1, 2 | Status indicator for read/write heads green: command at read/write head active yellow: approx. 1 second long, if command was successfully executed |
LEDs CH1, CH2 | green: read head detected red: Configuration error |
LED PWR/ERR | green: power on red: Hardware fault |
LED RUN | Off: init Flashing (green): pre-operational Single flash (green): safe-operational On (green): operational |
Electrical specifications | |
Rated operating voltage | 20 ... 30 V DC , PELV |
Ripple | ? 10 % at 30VDC |
Current consumption | ? 4 A incl. read/write heads |
Power consumption | 3.5 W Without read/write heads |
Galvanic isolation | basic insulation acc. to DIN EN 50178, rated insulation voltage of 50 Veff |
Interface 1 | |
Interface type | EtherCAT (IN) |
Physical | Ethernet |
Protocol | EtherCAT |
Transfer rate | 100 MBit/s |
Interface 2 | |
Interface type | EtherCAT (OUT) |
Physical | Ethernet |
Protocol | EtherCAT |
Transfer rate | 100 MBit/s |
Interface 3 | |
Interface type | Diagnostic Interface |
Physical | RS 232 |
Protocol | ASCII |
Transfer rate | 38.4 kBit/s |
Directive conformity | |
Electromagnetic compatibility | |
Standard conformity | |
Degree of protection | IEC60529:2001 |
Ambient conditions | |
Ambient temperature | -25 ... 70 °C (-13 ... 158 °F) |
Storage temperature | -40 ... 85 °C (-40 ... 185 °F) |
Climatic conditions | air humidity max. 96 % Salt spray resistant to EN60068-2-52 |
Shock and impact resistance | Oscillation (Sine): 5 g, 10 - 1000 Hz to EN 60068-2-6 Shock (Half-sine): 30 g, 11 ms in accordance with EN 60068-2-27 |
Mechanical specifications | |
Degree of protection | IP67 |
Connection | Read/write heads: shielded, 4-pin, M12 connector Power supply: M12 connector Protective earth: M4 earthing screw Diagnostic RS232: M8 connector EtherCAT: M12 connector, D-coded |
Material | |
Installation | screw fixing |
Mass | approx. 300 g |
8 (029) 555-8-000 | |
<span style="font-si</h3> |